Memoria HyperX Fury DDR3 8GB 1600mhz

CL(IDD) 10 cycles

Row Cycle Time (tRCmin) 44.75ns (min.)

Refresh to Active/Refresh 260ns (min.)

Command Time (tRFCmin)

Row Active Time (tRASmin) 32.125ns (min.)

Maximum Operating Power TBD W*

UL Rating 94 V – 0

Operating Temperature 0°C to 85°C

Storage Temperature -55°C to +100°C

*Power will vary depending on the SDRAM used.

•JEDEC standard 1.5V (1.425V ~1.575V) Power Supply

•VDDQ = 1.5V (1.425V ~ 1.575V)

•933MHz fCK for 1866Mb/sec/pin

•8 independent internal bank

•Programmable CAS Latency: 13, 11, 10, 9, 8, 7, 6

•Programmable Additive Latency: 0, CL – 2, or CL – 1 clock

•8-bit pre-fetch

•Burst Length: 8 (Interleave without any limit, sequential with

starting address “000” only), 4 with tCCD = 4 which does not

allow seamless read or write [either on the fly using A12 or

MRS]

•Bi-directional Differential Data Strobe

•Internal(self) calibration : Internal self calibration through ZQ

pin (RZQ : 240 ohm ± 1%)

•On Die Termination using ODT pin

•Average Refresh Period 7.8us at lower than TCASE 85°C,

3.9us at 85°C < TCASE < 95°C

•Asynchronous Reset

•PCB : Height 1.180” (30.00mm), double sided component